Pfohl - Glue with sponge rubber roller red

Pfohl - Glue with sponge rubber roller red

Standard roller for white glue, paste and other water-dilutable glues. It is advisable to purchase a second sponge rubber roller so that one can be washed out and dried at a time.

The advantages of the Pfohl gluers!

1. Completely even and metered application of glue.
2. No scraping of glue on the edges of joints and lattice gluing.
3. Effortless glue application on curved surfaces.
4. Possibility of using glues with shorter open times even with large surfaces, which enables shorter pressing times - thus better utilization of the presses.
5. For glues and adhesives of all kinds.
6. Compared to the previous brush and spatula application, approx. 30% glue savings.
7. Also at least 50% labor saving.

Operation manual:
Swivel the locking bracket in the direction of the handle and fill the glue container with glue or glue.
The locking bracket is then to be tilted forward and rolled over the surface strip by strip, which will apply the glue to the surface.
The glue feed is interrupted by swiveling the locking bar back and the glue is distributed completely evenly by rolling it over again.
A notice ! If you remove the dosing roller when cleaning the glue - beware of the sharp edge - only clean this area with tools! e.g. brush.

Care :

Different glues have the property of causing the sponge rubber roller to swell.
This swelling of the roller can easily be avoided with proper handling!
The sponge rubber roller is thoroughly cleaned after work as follows:

    The axle is pulled out of the roller
    Put the roller with the opening over a water tap, squeeze it tight, turn on the water tap and hold the lower end of the roller closed. As a result, the glue in the roller is pressed from the inside outwards by the water pressure, so that the roller is almost completely free of glue in about 2 minutes
    The roller is left to dry for 24 hours