Pfohl - Gluer with gray foam rubber roller

Pfohl - Gluer with gray foam rubber roller

With ribbed, non-porous surface, for white glues, but also for glues with added hardener (kaurite glue). This roller provides a weaker glue application, e.g. when working with veneer with coarse-pored veneer.

The advantages of the Pfohl gluers!

1. Completely even and metered application of glue.
2. No scraping of glue on the edges of joints and lattice gluing.
3. Effortless glue application on curved surfaces.
4. Possibility of using glues with shorter open times even with large surfaces, which enables shorter pressing times - thus better utilization of the presses.
5. For glues and adhesives of all kinds.
6. Compared to the previous brush and spatula application, approx. 30% glue savings.
7. Also at least 50% labor saving.

Operation manual:
Swivel the locking bracket in the direction of the handle and fill the glue container with glue or glue.
The locking bracket is then to be tilted forward and rolled over the surface strip by strip, which will apply the glue to the surface.
The glue feed is interrupted by swiveling the locking bar back and the glue is distributed completely evenly by rolling it over again.
A notice ! If you remove the dosing roller when cleaning the glue - beware of the sharp edge - only clean this area with tools! e.g. brush.

Care :

Because of the closed surface, these rollers are very easy to clean.
However, it is essential to ensure that this surface is not damaged by wringing, pulling, scratching or the like. is not damaged, otherwise the glue can penetrate the roller and also cause it to swell.
It is then no longer possible to remove the glue, which is why it is advisable to treat it carefully as described above.
The material of these rollers is not acid-resistant, so that cleaning with nitro thinner or turpentine is not allowed.